brentwooddental.com

12V EL wire/tape inverter : ID 448 : $4.95 : Adafruit Industries

4.9 (683) · € 24.99 · Auf Lager

adafruit-12V El Wire/Tape Inverter

A really tiny portable inverter for EL wire. Powers off of a single AAA battery (not included!), it can drive up to 50cm / 20 inches of our high-brightness EL wire or 10cm x 1cm long piece of EL tape for 3 hours (or longer if the EL wire is less than 50cm long). There is a switch on the side for selecting steady/blink/off modes. Comes with a 2.5mm pitch female JST connector.

adafruit-EL Wire 1xAAA Mini Inverter

A small, portable inverter for EL wire. Powers off of 2 AA batteries (not included!), it can drive 1 to 8 feet (about 2.5m) of our high-brightness EL

EL wire 2xAA pocket inverter

12V EL wire/tape inverter - Kamami on-line store

A really tiny portable inverter for EL wire. Powers off of a single AAA battery (not included!), it can drive up to 50cm / 20 inches of our

EL Wire 1xAAA Mini Inverter

EL wire 2xAA pocket inverter : ID 317 : $4.95 : Adafruit Industries, Unique & fun DIY electronics and kits

EL Wire/Tape/Panel Products Category on Adafruit Industries

adafruit-EL Wire Sound Activated Pocket Inverter - 5V USB Power

A really tiny portable inverter for EL wire. Powers off of a single AAA battery (not included!), it can drive up to 50cm / 20 inches of our high-brightness EL wire or 10cm x 1cm long piece of EL tape for 3 hours (or longer if the EL wire is less than 50cm long). There is a switch on the side for selecting steady/blink/off modes. Comes with a 2.5mm pitch female JST connector.

adafruit-EL Wire 1xAAA Mini Inverter

EL Wire/Tape/Panel Products Category on Adafruit Industries

adafruit-12V El Wire/Tape Inverter

12V EL wire/tape inverter : ID 448 : $4.95 : Adafruit Industries, Unique & fun DIY electronics and kits

12V EL wire/tape inverter : ID 448 : $4.95 : Adafruit Industries, Unique & fun DIY electronics and kits

A little bundle to get you started! This project pack contains

EL wire starter pack - Green 2.5 meter (8.2 ft)

Circuito per pilotare in pwm le strisce El wire. - Hardware - Arduino Forum